Is there a mismatch between the ordering of output, or the

Everything about quantification of recurrence plots and recurrence networks.
Post Reply
albernathy0
Junior
Posts: 2
Joined: Sun Jul 1, 2012 17:25
Affiliation (Univ., Inst., Dept.): Florida Atlantic University
Location: Delray Beach, FL, USA
Research field: Psychology

Is there a mismatch between the ordering of output, or the

Post by albernathy0 »

Hi Dr. Marwan,

I am confused by the ordering of the output of the CRQA toolbox.

My confusions:

1) In the GUI, T1 becomes RTE when "apply" is clicked. The value when "stored" is outputed to Y(:,9), which the manual states is T1. Why then does T1 become renamed to RTE in the GUI? Is this a software mistake?

2) The T2 value displayed in the GUI, when outputted, is placed in Y(:,11), which the manual states is RTE [not T2]. Comparing the GUI with the "stored" output, T2 has discrepant values.

3) When I calculate the RPDE of my time series using the RPDE function with the same parameters as in the GUI, I get discrepant entropy values. Shouldn't the RPDE be similar to Y(:,11)? And Y(:,11) is the T2 value (not the RTE value)!

So is there a mismatch between the ordering of output, or the GUI display?

Thank you greatly,
Alex Wong
User avatar
Norbert
Expert
Posts: 183
Joined: Wed Jan 4, 2006 11:03
Affiliation (Univ., Inst., Dept.): Potsdam Institute for Climate Impact Research, Germany
Location: Potsdam, Germany
Location: Potsdam Institute for Climate Impact Research, Germany

Re: Is there a mismatch between the ordering of output, or t

Post by Norbert »

Hi Alex,

thank you very much for this bug report. I will have check. Perhaps it is a bug in the code.

Best regards
Norbert
Post Reply